Keg Tanks and parts

Tint Keg Replacement Inline Filter for the Tint Keg inline water filters 250 mesh (40 micron) stainless steel with a poly body

Tint Keg Liquid Post w/ Popit

Tint Keg 30 foot Hose. Includes inline filter, brass nozzle and quick disconnect 

Tint Keg 5 Gallon Dual Sprayer Conversion Kit   This is everything that you need to make your tank have a second liquid out for a 2 hose set up. This kit only fits ball lock tanks. 2nd hose set up must be purchased separately.

Tint Keg 3 Gallon Dual Sprayer Conversion Kit   This is everything that you need to make your tank have a second liquid out for a 2 hose set up. This kit only fits ball lock tanks. 2nd hose set up must be purchased separately.

Tint Keg Inline Filter

Brass Gun Repair Kit

Tire Valve Inlet

Safety Relief Valve

Everything needed to reseal your TriggerJet spray guns. Expect about 10 minutes bench time your first time, after that you will spend 5 minutes or less as these are an easy fix.  TIP: Remember that when you have all the parts out, to blow out the...

TriggerJet Replacement trigger fits A1105N. Easy to replace, just use a small nail or an awl and tap the push pin put, then slide trigger towards the nozzle and lift off. Set new trigger in position and use original push pin to secure. Please...

Stress relief for coiled hose ends. Slip this poly tube over the end of our coiled hose to protect ends from kinking. Our Hose Clamp (A1100HC) is sized to fit over this short tube and clamp the ends tight. TIP: a drop of WD-40 will make this slip right...